Toyota Corolla (E120): Power point socket assy

Replacement

Hint

: components:

1. Remove floor shift shift lever knob sub–assy (m/t transaxle)

2. Remove console panel upper

3. Remove power point socket assy

  1. Turn the socket in the circumference direction as shown the illustration, disengage the claw between the socket and the power point socket cover, and push out the socket to the room side.
  2. align the socket with the notch on the power point socket cover, remove the power point socket assy to the room side.

4. Install power point socket assy

  1.  align the socket with the notch on the power point socket cover, push the power point socket assy into as hard as possible and install it.
    Share this page:

    Other materials:

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Towing with a wheel-lift type truck
    ► From the front Release the parking brake. ► From the rear Use a towing dolly under the front wheels. Vehicles without a smart key system: When not using a towing dolly, turn the engine switch to the “ACC” position and shift the shift lever to N. Vehicles with a smart key ...

    Under hood
    General maintenance 1. General notes maintenance requirements vary depending on the country. Check the maintenance schedule in the owner’s manual supplement. Following the maintenance schedule is mandatory. Determine the appropriate time to service the vehicle using either miles driv ...