Toyota Corolla (E120): Cigarette lighter assy

Replacement

Hint: components:

1. Remove floor shift shift lever knob sub–assy (m/t transaxle)

2. Remove console panel upper

3. Remove cigarette lighter cover

  1. Disengage the 2 claws and remove the cigarette lighter cover.

4. Remove cigarette lighter assy

  1. Turn the socket in the circumference direction as shown in the illustration, disengage the claw between the socket and the cigarette lighter bezel stay, and push out the socket to the room side.
  2.  align the socket with the notch on the cigarette lighter bezel stay, remove the cigarette lighter assy to the room side.

5. Install cigarette lighter assy

  1.  align the socket with the notch on the cigarette lighter bezel stay, push the cigarette lighter assy into as hard as possible and install it.
    Share this page:

    Other materials:

    Circuit description
    When driving uphill under cruise control, in order to reduce the number of shifting due to on–off overdrive operation and to provide smooth driving, when down shifting in the electronically controlled transmission occurs, a signal to prevent upshift until the end of the uphill slope is sent ...

    Overhaul
    Hint: installation is in the reveres order of the removal. But the installation is indicated only when it has a point. In the rh side, work in the same procedure as in the lh side. 1. Remove rear armrest assy lh Using a screwdriver, remove the rear armrest. Hint: tape the s ...

    How to proceed with troubleshooting
    1 Vehicle brought to workshop 2 Customer problem analysis 3 Check and clear dtc 4 Problem symptom confirmation Symptom does not occur (go to step 5) 5 Symptom simulation 6 Dtc check 7 Dtc chart 8 Problem symptoms table 9 Circuit inspection 10 Confirmation test End ...