Toyota Corolla (E210) 2019-2026 Owners Manual / Driving / Operating the lights and wipers
Toyota Corolla (E210): Operating the lights and wipers
Other materials:
On–vehicle inspection
1. Connect hand–held tester:
connect the hand–held tester to the dlc3.
start the engine and run it at idle.
select the active test mode on the hand–held tester.
Hint:
please refer to the hand–held tester operator’s manual for further details.
2. Inspect actua ...
Inspection procedure
1 Check hazard warning signal switch assy
Check the hazard warning switch continuity, as shown in
the illustration and table.
Standard:
2 Check turn signal flasher assy
3 Check wire harness (tvip ecu turn signal flasher)
Disconnect the tvip ecu and turn signal flashe ...
RCTA (Rear Cross Traffic Alert)
function
The RCTA function uses the
BSM rear side radar sensors
installed behind the rear
bumper. This function is
intended to assist the driver
in checking areas that are
not easily visible when
backing up.
WARNING
■Cautions regarding the use of
the system
The driver is solely responsible for
safe driving ...