Toyota Corolla (E120): Body
On–vehicle inspection
1. Canada:
tighten bolts and nuts on chassis and body
- tighten the bolts and nuts on the chassis parts listed below, if necessary
- Front axle and suspension
- drive train
- rear axle and suspension
- brake system
- engine mounting
- other chassis parts
- tighten the bolts and nuts on the body parts listed below, if necessary.
- Seat belt system
- seats
- doors and hood
- body mountings
- fuel tank
- exhaust pipe system
- other body parts
2. Replace air conditioning filter
- remove the glove compartment assembly.
- remove the filter case from the filter outlet.
- remove the filter from the filter case.
- replace the filter with a new one.
- the installation procedures are the removal procedures in reverse order.
Other materials:
Emission inspection and maintenance (I/M) programs
Some states have vehicle
emission inspection programs
which include OBD
(On Board Diagnostics)
checks. The OBD system
monitors the operation of
the emission control system.
If the malfunction indicator
lamp comes on
The OBD system determines
that a problem exists somewhere
in the emission control
sy ...
Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat
outer belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...
Overhaul
Hint:
installation is in the reveres order of the removal. But the
installation is indicated only when it has a
point.
In the rh side, work in the same procedure as in the lh side.
1. Remove rear armrest assy lh
Using a screwdriver, remove the rear armrest.
Hint:
tape the s ...


