Toyota Corolla (E120): Inspection procedure

1 Check wire harness(dlc3 – airbag sensor assy center)

  1. Turn the ignition switch to the lock position.
  2.  disconnect the aribag sensor assy center connector.
  3.  measure the resistance according to the value(s) in the table below.

Standard:

2 Check wire harness(cg of dlc3 – body ground)

2 Check wire harness(cg of dlc3 – body ground)

  1. Measure the resistance according to the value(s) in the table below.

Standard:

3 Check wire harness(tc of airbag sensor assy center – body

3 Check wire harness(tc of airbag sensor assy center – body ground)

  1. Measure the resistance according to the value(s) in the table below.

Standard:

Replace air bag sensor assy center

Replace air bag sensor assy center

    Share this page:

    Other materials:

    How to register a Bluetooth® device
    1 Display the “Bluetooth* Setup” screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. 2 Select “Add”. 3 When this screen is displayed, search for the device name displayed on this screen on the screen of your Bluetooth® device. For details about operating the Bluetoo ...

    On–vehicle inspection
    1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds. disconnect the connectors between the front seat airbag assy (rh) and the airbag sensor assy center. ...