Toyota Corolla (E120) 2002–2008 Repair Manual / Maintenance
Toyota Corolla (E120): Maintenance
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...
If the engine will not start
If the engine will not start even though correct starting procedures are being
followed , consider each of the following points:
The engine will not start even though the starter motor operates normally.
One of the following may be the cause of the problem:
● There may not be sufficient f ...
Light control switch circuit
Wiring diagram
Inspection procedure
1 Check headlamp dimmer switch assy (light control switch)
2 Check wire harness (tvip ecu light control switch)
Disconnect the tvip ecu and light control switch connectors.
check the continuity between the terminals of the tvip
e ...