Toyota Corolla (E210): Gauges and meters (4.2-inch display)

Share this page:

Other materials:

Inspection procedure
1 Inspect shift solenoid valve(s1) Remove the shift solenoid valve s1. measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

Engine hood/door
Preparation Sst Recomended tools Equipment ...