Toyota Corolla (E120): Malfunction in fuel receiver gauge

Wiring diagram

Inspection procedere

Inspection procedere

1 Inspect fuel sender gage assy

  1. Disconnect the connector fuel sender gauge.
  2. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector.

    Check that the resistance value changes continuously.

Standard:

2 Check harness and connector(between fuel sender gage and

2 Check harness and connector(between fuel sender gage and combination meter assy)

Check and replace combination meter assy

Check and replace combination meter assy

    Share this page:

    Other materials:

    When the contact is empty
    You can transfer the phone numbers in a Bluetooth® phone to the system. Operation methods differ between PBAP (Phone Book Access Profile) compatible and PBAP incompatible Bluetooth® phones. If the cellular phone does not support either PBAP or OPP (Object Push Profile) service, you cannot tra ...

    Overhaul
    1. Remove console panel upper 2. Remove console box carpet 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Disconnect floor shift cable transmission control shift Remove the cable end from the rod of the floor shift assembly. Using a s ...

    Inspection procedure
    Hint: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the ...