Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter
Toyota Corolla (E120): Combination meter
- How to proceed with troubleshooting
- Location
- Terminals of ecu
- Entire combination meter does not operate
- Malfunction in speedometer
- Malfunction in tachometer
- Malfunction in fuel receiver gauge
- Malfunction in water temperature receiver gauge
- Warning buzzer does not sound (key reminder warning, light reminder warning)
- Seat belt warning lamp for driver’s seat does not operate
- Seat belt warning lamp for front passenger’s seat does not flash
- Malfunction in clock
- The ambient temperature does not display
Other materials:
Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle
shift switches. The gear steps can then be selected by operating the “-” and “+”
paddle shift switches. By selecting gear step using paddle shift switches, you can
control engine braking forces.
1 ...
Overhaul
Hint: components:
1. Remove rear wheel
2. Remove spare wheel cover assy
3. Remove rear floor finish plate
4. Remove luggage compartment trim cover inner lh
5. Remove rear shock absorber with coil spring
Support the rear axle beam with jack.
Remove the 2 nuts and bolt.
...
Inspection procedure
1 Check airbag sensor assy center connector
Disconnect negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
check the connection of the airbag sensor assy center connectors.
2 Check air bag sensor assy center
Sst 09843–18040
Connect the n ...