Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter / Seat belt warning lamp for driver’s seat does not operate

Toyota Corolla (E120): Seat belt warning lamp for driver’s seat does not operate

Wiring diagram

Inspection procedure

Inspection procedure

1 Check combination meter assy

  1. Ground terminal c9–12 on the combination meter side.
  2. check that the warning lightlights up.

    Ok: warning light lights up.

2 Inspect front seat inner belt assy lh

2 Inspect front seat inner belt assy lh

  1. Disconnect the front seat inner belt assy.
  2.  check continuity front seat inner belt assy.

Repair or replace harness or connector

Repair or replace harness or connector

    Share this page:

    Other materials:

    Check short circuit
    If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...

    Components
    ...

    Stabilizer bar rear
    Replacement Hint: components: 1. Remove stabilizer bar rear Remove the 2 bolts, nuts and stabilizer bar. 2. Install stabilizer bar rear Install the 2 bolts, nuts and stabilizer bar. Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf) Hint: install the stabilizer bar so that the ...