Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter / Warning buzzer does not sound (key reminder
warning, light reminder warning)
Toyota Corolla (E120): Warning buzzer does not sound (key reminder warning, light reminder warning)
Wiring diagram
Inspection procedere
1 Check buzzer
- Check that all of the warning buzzers sound.
2 Inspect front door courtesy lamp switch assy
3 Inspect un–lock warning switch assy
4 Check harness and connector(between un–lock warning switch and combination meter assy)
5 Check harness and connector(between courtesy lamp switch and combination meter assy)
Check and replace combination meter assy
Other materials:
Circuit description
The ignition switch provides circuit power and the ecm provides the circuit
ground that illuminates the mil.
Mil operation is checked visually:
it should be illuminated when the ignition is first turned on. If the mil is off
all of the time or on all of the time,
use the procedure below to ...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Throttle body assy
Components
Removal & installation and disassembly & reassembly
1. Drain coolant
2. Remove cylinder head cover no.2
Remove 2 nuts, 2clips and the cylinder head cover no. 2.
3. Remove air cleaner cap sub–assy
Disconnect the maf connector.
disconnect the vsv co ...