Toyota Corolla (E120): Manual transmission/transaxle

Preparation

Sst

Equipment

Equipment

Lubricant

Lubricant

Clutch

    Share this page:

    Other materials:

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

    Inspection
    1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...