Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Actuator motor circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect cruise control actuator assy
- Turn the ignition switch to off.
- disconnect the cruise control actuator assy connector.
- measure the resistance between terminals 1 (mo) and 2 (mc) of cruise control actuator assy.
Hint
: if control plate position is fully opened or fully closed, resistance cannot be measured.
Ok: resistance: more than 4.2 Ω
2 Check harness and connector(between cruise control ecu assy and cruise control actuator assy)
- Check for open and short circuit in harness and connector between cruise control ecu assy and cruise control actuator assy (actuator motor)
Check and replace cruise control ecu assy
Other materials:
Circuit description
The purpose of this circuit is to prevent the engine from stalling while
driving in lock–up condition, when
brakes are suddenly applied.
When the brake pedal is depressed, this switch sends a signals to the ecm. Then
the ecm cancels the operation
of the lock–up clutch while braking is i ...
Uniform Tire Quality Grading
This information has been prepared in accordance with regulations issued by the
National Highway Traffic Safety Administration of the U.S. Department of Transportation.
It provides the purchasers and/or prospective purchasers of Toyota vehicles with
information on uniform tire quality grading.
...
Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat
outer belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...