Toyota Corolla (E120): Actuator magnetic clutch circuit

Dtc 12 actuator magnetic clutch circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect brake booster Airtightness check.  Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly. Hint: if the pedal goes down farthest at the 1st time, but gradually rises after the 2nd or 3rd time, the booster is airtight. ...

Inspection procedure
1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...

Adjustment
1. Check and adjust brake pedal height Inspect brake pedal height. Pedal height from asphalt sheet: m/t: 134.9 – 144.9 Mm (5.311 – 5.703 In.) A/t: 136.0 – 146.0 Mm (5.353 – 5.747 In.)  Disconnect the connector from the stop lamp switch.  Remove the stop lamp ...