Toyota Corolla (E120): Automatic transmission / trans

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Lubricant

Lubricant

Ssm (special service materials)

Ssm (special service materials)

Manual transmission/transaxle

    Share this page:

    Other materials:

    Check and replace ecu
    Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...

    Inspection procedure
    1 Inspect transmission wire(s1) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

    Things you should know
    ■ If you notice any symptoms If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. CAUTION ■When using the rear view monitor system ...