Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Manual transaxle oil
Toyota Corolla (E120): Manual transaxle oil
On–vehicle inspection
1. Inspect transaxle oil

- Stop the vehicle on the level place.
- remove the transmission filler plug and gasket.
- check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug opening.
Notice
:
- excessively large or small amount of oil may cause troubles.
- After replacing oil, drive the vehicle and check the oil level.
- check for oil leakage when the oil level is low.
- install the transmission filler plug and new gasket.
Torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf)
Other materials:
Lubrication system
*: The engine oil capacity is a reference quantity to be used when changing the
engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check
the oil level on the dipstick.
■ Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toyo ...
Replacement
Hint: components:
1. Precaution
2. Disconnect battery negative terminal
3. Remove air bag front rh sensor
Disconnect the connector from the airbag front rh sensor.
remove the 2 bolts and airbag front rh sensor.
4. Inspect air bag front rh sensor
5. Install air bag front rh ...
Using the key (vehicles
without a smart key system
and with a wireless
remote control function)
Releasing
To release the key, press the button
Folding
To stow the key, press the button
then fold the key.
Using the mechanical key
(vehicles with a smart key
system)
To take out the mechanical key,
slide the release button and take
the key out.
The mechanical key can only be
inserted in o ...


