Toyota Corolla (E120): Clutch

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Lubricant

Lubricant

Steering column

    Share this page:

    Other materials:

    Replacement
    1. Work for preventing gasoline from spilling out 2. Remove engine under cover rh 3. Drain coolant 4. Remove front wheel rh 5. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 6. Remove air cleaner hose no.1  loosen the 2 air cleaner hose ...

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...