Toyota Corolla (E210) 2019-2026 Owners Manual / Driving / Using the driving support systems
Toyota Corolla (E210): Using the driving support systems
- Toyota Safety Sense 3.0 software update
- Toyota Safety Sense 3.0
- PCS (Pre-Collision System)
- LTA (Lane Tracing Assist)
- LDA (Lane Departure Alert)
- PDA (Proactive driving assist)
- RSA (Road Sign Assist)
- Dynamic radar cruise control
- Using the dynamic radar cruise control
- Cruise control
- Emergency Driving Stop System
- BSM (Blind Spot Monitor)
- Blind Spot Monitor operation
- RCTA (Rear Cross Traffic Alert) function
- RCTA function
- Safe Exit Assist
- Driving mode select switch
- Driving assist systems
Other materials:
Inspection procedure
1 Input signal check
See input signal check on page 05–745.
check the indicator light operation when each of the set/
coast, resume/accel and cancel is turned on.
Ok:
set/coast, resume/accel switch:
the signals shown in the table on the left should be
output when each switch is ...
Inspection
1. Cooler thermistor no.1
Check resistance between terminals 1 and 2 of cooler
thermistor no. 1 At each temperature, as shown in the
chart.
Resistance:
If resistance value is not as specified, replace the sensor.
2. Cooler and accessory assy
Inspect blower switch contin ...
Overhaul
Caution:
wear the gloves, because the cutting surface of the seat back frame and seat
adjuster may injure
your hand.
Hint:
tape the screwdriver tip before use when prying parts.
1. Disconnect battery negative terminal
Caution:
wait for 90 seconds after disconnecting the battery terminal a ...