Toyota Corolla (E210): Toyota Safety Sense 3.0 software update

It is necessary to enter a connected services contract, provided by Toyota, to use these functions. For details, contact your Toyota dealer.

WARNING

■For safe use

When the Toyota Safety Sense 3.0 software is updated, the operating methods of functions may change. Using this system without knowing the correct operating methods may lead to an accident resulting in death or serious injury.

  • Make sure to read the Digital Owner's Manual which corresponds to the software version of the system, available at the Owner's Manual website, before using this system.

Content of the Toyota Safety Sense Owner's Manual

This Owner's Manual contains information for Ver. 1 For the latest information about the controls, use, warnings/precautions, etc. of each function of Toyota Safety Sense, refer to the Digital Owner's Manual at the Owner's Manual website.

If the software of this system has been updated after initial purchase of the vehicle, before using this system, be sure to read the Owner's Manual which corresponds to the software version of the system.

■Precautions for use

  • Be aware that some functions may temporarily be disabled if a legal or safety related issue occurs.
  • If a connected services contract has not been entered or has expired, software updates will not be able to be performed wirelessly.

Updating the software

If a software update is available, a notification will be displayed by Toyota app. Follow the instructions displayed on the screen.

■Software update precautions

  • After a software update has been performed, it will not be possible to revert to a previous version.
  • Depending on the communication environment and the content of an update, a software update may take several hours. Although an update will be suspended when the engine switch is turned off, it will resume when the engine switch is changed back to ON mode.
  • Toyota Safety Sense can still be used while a software update is being performed.

■What can be checked using the Toyota app

The following items can be checked or performed.

  • Software version, update details, precautions, use methods, etc.
  • Software update
    Share this page:

    Other materials:

    Inspection procedure
    1 Check un–lock warning switch assy Disconnect the key unlock warning switch connector.  check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu unlock warni ...

    Circuit description
    Refer to dtc p0115 Dtc no. Dtc detection condition Trouble area P0116 If engine coolant temperature (ect) was between 35 c (95 °F) and 60 c (140 °F) when starting the engine, and also conditions (a) and (b) are met:  vehicle has run with acceleration an ...

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...