Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system
Toyota Corolla (E120): Sfi system
- How to proceed with troubleshooting
- Customer problem analysis check
- Location
- Diagnosis system
- Dtc check/clear
- Check mode procedure
- Basic inspection
- Terminals of ecm
- Data list/active test
- Definition of terms
- Toyota/lexus part and system name list
- List of disable a monitor
- Checking monitor status
- Readiness monitor drive pattern
- Diagnostic trouble code chart
- Fail–safe chart
- Problem symptoms table
- Camshaft position ”a” actuator circuit
- Camshaft position ”a” –timing over
- Crankshaft position – camshaft position correlation
- Oxygen sensor heater control circuit...
- Mass or volume air flow circuit
- Mass or volume air flow circuit range/performance problem
- Intake air temperature circuit
- Engine coolant temperature circuit
- Engine coolant temp. Circuit range/performance problem
- Throttle/pedal position sensor/switch ”a” circuit
- Throttle/pedal position sensor/switch ”a” circuit range/performance problem
- Insufficient coolant temperature for closed loop fuel control
- Coolant thermostat (coolant temperature below thermostat regulating temperature)
- Oxygen sensor
- Oxygen sensor circuit slow response
- Oxygen sensor circuit no activity detected
- Oxygen sensor circuit malfunction
- System too lean/rich
- Random/multiple cylinder misfire detected
- Knock sensor 1 circuit
- Crankshaft position sensor ”a” circuit
- Camshaft position sensor ”a” circuit
- Ignition coil primary/secondary circuit
- Catalyst system efficiency below threshold
- Evaporative emission control system
- Evaporative emission control system leak detected
- Evaporative emission control system pressure sensor
- Vehicle speed sensor ”a”
- Idle air control System/ Circuit
- System voltage
- Ecm/pcm processor
- Starter relay circuit high
- Ecm power source circuit
- Fuel pump control circuit
- Stop light switch circuit
- Mil circuit
Other materials:
Precaution
Caution:
the corolla is equipped with srs, which comprises a driver airbag,
front passenger airbag
and side airbag. Failure to carry out service operations in the correct
sequence could cause
the srs to unexpectedly deploy during servicing, possibly leading to a
serious accident. Fu ...
Inspection procedure
1 Check door lock
When the door does not operate manually, proceed to ”a”.
when the door does not operate via the key, proceed to ”b”.
2 Inspect door lock control switch
W/ power window:
remove the power window regulator master switch assy.
Inspect th ...
Inspection procedure
Hint:
if different dtcs related to different systems that have terminal e2
as the ground terminal are output
simultaneously, terminal e2 may be open.
If dtc p0441 (purge flow), p0446 (vsv for ccv), p0451, p0452 or p0453
(evaporative pressure
sensor) is output with dtc p0442 or p0456, ...