Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Throttle/pedal position sensor/switch ”a” circuit range/performance problem

Toyota Corolla (E120): Throttle/pedal position sensor/switch ”a” circuit range/performance problem

Dtc p0121 throttle/pedal position sensor/switch ”a” circuit range/performance problem

Hint

: this is the purpose of the ”throttle position sensor”.

Share this page:

Other materials:

Replacement
1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu assy. The cruise control ecu assy uses this signal to correct the discrepancy between the throttle valve position and the actuator position sensor values to enable accurate cruise control at the set speed. If the idl ...