Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Crankshaft position – camshaft position correlation

Toyota Corolla (E120): Crankshaft position – camshaft position correlation

Dtc p0016 crankshaft position – camshaft position correlation (bank 1 sensor a)

Share this page:

Other materials:

Side mudguard sub–assy lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

Replacement
1. Remove radiator grille sub–assy 2. Remove front bumper cover 3. Remove fog lamp assy lh Remove a nut and release a claw.  remove the fog light assy lh. 4. Put vehicle these conditions 5. Adjust fog light aim 6. Check fog light aim ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...