Toyota Corolla (E120): Fuel pump control circuit

Share this page:

Other materials:

Adjustment
Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect rear door panel sub–assy lh Check ...

Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...

Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu assy. The cruise control ecu assy uses this signal to correct the discrepancy between the throttle valve position and the actuator position sensor values to enable accurate cruise control at the set speed. If the idl ...