Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Camshaft position ”a” actuator
circuit
Toyota Corolla (E120): Camshaft position ”a” actuator circuit
Dtc p0010 camshaft position ”a” actuator circuit (bank 1)
Other materials:
Inspection procedure
1 Check p/t squib(rh) circuit(airbaga sensor assy center – front
seat outer belt assy rh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensi ...
Terminals of ecu
1. Inspect integration relay
Disconnect the connector from the integration relay.
check the continuity between each terminal of the disconnected connector
and the body ground, as
shown in the illustration and table.
Standard:
If the result is not as specified, the vehicle’s ...
Safety information for
Safety Connect
Important! Read this information
before using Safety Connect.
■ Exposure to radio frequency
signals
The Safety Connect system
installed in your vehicle is a
low-power radio transmitter and
receiver. It receives and also
sends out radio frequency (RF)
signals.
In August 1996, the Federal
Communica ...