Toyota Corolla (E120): Oxygen sensor circuit slow response

Dtc p0133 oxygen sensor circuit slow response (bank 1 sensor 1)

Share this page:

Other materials:

Monitor description
While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

Circuit description
The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b1185/57 is recorded when a short is detected in the p squib (2nd step) circuit. Wiri ...

Turning on light switch does not light up night time illumination of radio receiver
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(ill+, ill–) Check that the voltage between terminals at each condition, as shown in the chart. Standard: Repair or replace harness or connector ...