Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures / Continuously variable transmission (vehicles with paddle shift switches) / Temporarily engaged gear steps selection mode in the D position
Toyota Corolla (E170): Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces.
1 Upshifting
2 Downshifting
The selected gear step, from D1 to D7, will be displayed in the meter.
To return to normal D position driving, the “+” paddle shift switch must be held down for a period of time

Other materials:
Overhaul
1. Drain clutch fluid
2. Remove brake master cylinder sub–assy
3. Remove brake booster assy
4. Disconnect clutch reservoir tube
Loosen the clip and disconnect the clutch reservoir tube
from the clutch master cylinder assy.
Hint:
use a container to catch the fluid.
5. Disconnect ...
Overhaul
Hint: components:
1. Remove rear wheel
2. Remove spare wheel cover assy
3. Remove rear floor finish plate
4. Remove luggage compartment trim cover inner lh
5. Remove rear shock absorber with coil spring
Support the rear axle beam with jack.
Remove the 2 nuts and bolt.
...
Circuit description
The seat belt buckle switch (lh) circuit consists of the airbag sensor assy
center and front seat inner belt
assy (lh).
Dtc b0126/b0127/27 is recorded when a malfunction is detected in the seat belt
buckle switch (lh) circuit.
Wiring diagram
...


