Toyota Corolla (E120): Location
*1: Only for a/t
Other materials:
Terminals of ecu
1. Inspect tvip ecu
Inspect the ecu–b, dome and ecu–ig fuses.
disconnect the tvip ecu connector, and the continuity and voltage of
check each terminal of the disconnected
connector.
Standard:
If the result is not as specified, the vehicle’s side may malfunction.
Reco ...
Circuit description
Refer to dtc p0115
Dtc no.
Dtc detection condition
Trouble area
P0125
If the engine coolant temperature (ect) was less than –6.6 °C
(20 °F) when starting the engine, and 20 minutes after the engine
start, the ect sensor still indicates below 20 °C (68 ...
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...