Toyota Corolla (E120): Engine coolant temperature circuit

Dtc p0115 engine coolant temperature circuit

Dtc p0117 engine coolant temperature circuit low input

Dtc p0118 engine coolant temperature circuit high input

Share this page:

Other materials:

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

On–vehicle inspection
1. Inspect sliding roof function  check the slide opening operation (manual).  Turn the ignition switch on.  When keeping operating the sliding roof switch to the open side, check that the roof glass will slide and be fully opened.  check the slide closing ...

On–vehicle inspection
1. Inspect air–fuel ratio compensation system Hint: you can also check the system by choosing ”data monitor”, then ”o2 sensor output voltage” on the monitor of the hand–held tester. Connect the hand–held tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...