Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Crankshaft position sensor ”a”
circuit
Toyota Corolla (E120): Crankshaft position sensor ”a” circuit
Dtc p0335 crankshaft position sensor ”a” circuit
Dtc p0339 crankshaft position sensor ”a” circuit intermittent
Other materials:
Overhaul
1. Remove repair service starter kit
Remove the nut, then disconnect the lead wire from terminal
c.
Remove the 2 screws which are used to secure the repair
service starter kit to the starter drive housing.
remove the repair service starter kit.
remove the return ...
Inspection procedure
Hint
Advanced timing over
(valve timing is out of specified range)
P0011
Retarded timing over
(valve timing is out of specified range)
P0012
If dtc p0011 or p0012 is displayed, check the vvt system circuit.
Read freeze frame data using the hand–held tester o ...
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...