Toyota Corolla Owners Manual
- For your information
- For safety and security
- Instrument cluster
- Warning lights and indicators
- Gauges and meters (drive monitor display)
- Gauges and meters (multi-information display)
- Eco Driving Indicator (except vehicles with a manual transmission)
- Operation of each component
- Key information
- Opening, closing and locking the doors
- Adjusting the seats
- Opening and closing the windows
- Driving
- Before driving
- Driving procedures
- Operating the lights and wipers
- Refueling
- Using the driving support systems
- Driving tips
- Interior features
- Basic Operations
- Using the audio system
- Using the radio
- Playing audio CDs and MP3/WMA discs
- Using an external device
- Using Bluetooth® devices
- “SET UP” menu
- Bluetooth® Audio
- Bluetooth® Phone
- Bluetooth®
- Basic Operations (Multimedia system)
- Setup (Multimedia system)
- Using the Multimedia system
- Using the radio (Multimedia system)
- Playing an audio CD and MP3/WMA/AAC discs (Multimedia system)
- Using an external device (Multimedia system)
- Connecting Bluetooth® (Multimedia system)
- Bluetooth® Audio (Multimedia system)
- Bluetooth® phone (Multimedia system)
- Bluetooth® (Multimedia system)
- Using the voice command system (Multimedia system)
- Interior features
- Using the air conditioning system and defogger
- Using the interior lights
- Using the storage features
- Other interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- What to do if... (Troubleshooting)
For your information
Main Owner’s Manual
Please note that this manual applies to all models and explains all equipment,
including options. Therefore, you may find some explanations for equipment not installed
on your ...
Other materials:
On–vehicle inspection
1. Inspect air–fuel ratio compensation system
Hint:
you can also check the system by choosing ”data monitor”,
then ”o2 sensor output voltage” on the monitor of the
hand–held tester.
Connect the hand–held tester to the terminal 23 (ox1a)
@ 7 (e1) and 21 (ox1b) @ 7 (e1) of the ecm.
Cau ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Read value of hand–held tester(skid control sensor)
Check that there is no difference between the speed value output from
the speed sensor displ ...
Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector of the airbag sensor assy center.
connect the negative (–) terminal cable to the battery,
and wait a ...