Toyota Corolla Owners Manual: When trouble arises
- Essential information
- Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- Fuel pump shut off system
- If a warning light turns on or a warning buzzer sounds
- If a warning message or indicator is displayed (vehicles with a multi-information display)
- If you have a flat tire
- If the engine will not start
- If the shift lever cannot be shifted from P (except vehicles with a manual transmission)
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
Replacing light bulbs
■ Headlight high beams
1 Turn the bulb base counterclockwise.
2 Pull the bulb out while pressing the lock release of the connector.
3 Replace the light bulb, and install the bulb base.
A ...
Other materials:
Replacement
Hint: components:
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire (w/ abs)
4. Remove rear axle hub & bearing assy lh
Remove the 4 bolts and hub & bearing assy lh.
5. Install rear axle hub & bearing assy lh
Install the ...
Seat belt warning lamp for front passenger’s seat
does not flash
Wiring diagram
Inspection procedure
1 Inspect combination meter assy
Ground terminal c9–11 on the combination meter side.
check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect passenger seat belt warning lamp assy
Ground terminal c9–6 on ...
Dtc check/clear
Notice:
if there is no dtc in the normal mode, check the pending
fault code using the continuous test results
function (mode 7 for sae j1979) on the obd ii scan
tool or the hand–held tester.
Hand–held tester only:
when the diagnosis system is switched from the normal
mode to the chec ...