Toyota Corolla (E170): Interior features

Share this page:

Other materials:

Removal and installation of engine intake parts
If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.  when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.  when inst ...

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

Inspection procedure
1 Check operation(overdrive) Drive the vehicle after the engine warms up.  check that overdrive on e off occurs by an operation of the o/d switch on–off. 2 Inspect terminal voltage(od) Remove the cruise control ecu assy with the connector still connected.  tur ...