Toyota Corolla (E170): Other interior features

Share this page:

Other materials:

Check and replace ecu
Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...

Pressing power switch does not start system
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(+b, acc, gnd) Check that the continuity between terminals at each condition, as shown in the chart. Standard: Check that the voltage between terminals at each condition, as shown in the chart. Standard: ...

Side mudguard sub–assy lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...