Toyota Corolla (E170): Other interior features

Share this page:

Other materials:

Replacement
1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

For vehicles equipped with catalytic converter
Caution: if large amount of unburned fuel flows into the converter, it may cause overheating and a fire hazard. To prevent this, observe the following precautions. Use only unleaded gasoline.  avoid prolonged idling. Avoid running the engine at idle speed for more than 20 minutes. ...