Toyota Corolla (E170): Clock

The clock can be adjusted.

1 Adjusts the hours
2 Adjusts the minutes
3 Rounds to the nearest hour*

*: e.g.1:00 to 1:29 → 1:00 1:30 to 1:59 → 2:00

Outside temperature display

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Check and replace ecu
    Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...