Toyota Corolla (E170): Instrument cluster

Share this page:

Other materials:

Thermostat
Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...

Problem symptoms table
If a normal code is displayed during the dtc check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page. Notice: when replacing skid control ecu, sensor or etc., Turn the ignition swi ...

Circuit description
In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...