Toyota Tacoma manuals

Toyota Corolla Owners Manual: Eco Driving Indicator Light customization

► Drive monitor display ► Multi-information display

■Operation of Eco Driving Indicator

Eco Driving Indicator will not operate in the following conditions:

●The shift lever is in any position other than D.

●Paddle shift switch* is operated.

●Sport mode* is selected.

●The vehicle speed is approximately 80 mph (130 km/h) or higher.

*: If equipped

Eco Drive Indicator Zone Display
Suggests Zone of Eco driving with current Eco driving ratio based on acceleration. 1 Eco driving ratio based on acceleration If the acceleration exceeds Zone of Eco driving, the right side of Eco Dr ...

Operation of each component
...

Other materials:

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and releas ...

Body rocker panel moulding lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...

Torque converter clutch and drive plate (atm)
Inspection 1. Inspect torque converter clutch assy Inspect the oneway clutch.  Set sst into the inner race of the oneway clutch. Sst 0935032014 (0935132010)  set sst so that it fits in the notch of the converter hub and outer race of the oneway clutch. Sst 09350 ...

2011-2018 Copyright www.tcorolla.net