Toyota Corolla (E120) 2002–2008 Repair Manual / Starting & charging
Toyota Corolla (E120): Starting & charging
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Data list/active test
1. Data list
Hint:
according to the data list displayed by the obd ii scan tool or hand–held
tester, you can read the value
of the switch, sensor, actuator and so on without parts removal. Reading the
data list as the first step of
troubleshooting is one method to shorten labor time.
W ...
Overhaul
Hint:
overhaul the rh side by the same procedure as the lh side.
1. Remove front wheel
2. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
3. Remove front disc brake cylinder sub–assy
Remove the union bolt and gasket ...