Toyota Corolla (E120): Precaution

1. Check that the battery cables are connected to the correct terminals.

2. Disconnect the battery cables when the battery is given a quick charge.

3. Do not perform tests with a high voltage insulation resistance tester.

4. Never disconnect the battery while the engine is running.

5. Check that the charging cable is tightened on terminal b of the alternator and the fuse box.

6. Do not check whether the alternator generates or not with connecting terminal f to other terminal.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Inspection procedure
    1 Inspect parking brake switch circuit Check for open and short circuit in parking brake switch circuit 2 Inspect brake fluid level warning switch circuit Check the brake fluid level in reservoir.  check for open and shot circuit in brake fluid level warning switch circuit ...

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...