Toyota Corolla (E120): Starter assy (1zz–fe)

Share this page:

Other materials:

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Automatic transaxle fluid (atm)
On–vehicle inspection 1. Check the fluid level Hint: drive the vehicle so that the engine and transaxle are at normal operating temperature. Fluid temperature: 70 – 80 °c (158 – 176 °f)  park the vehicle on a level surface and set the parking brake.  with the engin ...

When stopping the engine with the shift lever in a position other than P (vehicles with a continuously variable transmission)
If the engine is stopped with the shift lever in a position other than P, the engine switch will not be turned off but instead be turned to ACCESSORY mode. Perform the following procedure to turn the switch off: 1 Check that the parking brake is set. 2 Shift the shift lever to P. ► Vehi ...