Toyota Corolla (E120): Fuel

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

Disposal
1. Dispose shock absorber assy rear lh Fully extend the shock absorber rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, odorless and no ...

Replacement
1. Remove console box sub–assy rear 2. Remove parking brake lever sub–assy 3. Remove exhaust pipe assy front 4. Remove front floor heat insulator no.1 Remove the 3 nuts and front floor insulator no.1. 5. Remove front floor heat insulator no.2 Remove the 2 nuts and front ...