Toyota Corolla (E120): Fuel tank assy

Share this page:

Other materials:

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...

Follow the correction procedures. (vehicles with a smart key system and with a drive monitor display)
After taking the specified steps to correct the suspected problem, check that the warning light turns off. ■SRS warning light This warning light system monitors the airbag sensor assembly, front impact sensors, side impact sensors (front door), side impact sensors (front), side impac ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...