Toyota Corolla (E120) 2002–2008 Repair Manual / Preparation
Toyota Corolla (E120): Preparation
- Diagnostics
- Fuel
- Emission control
- Engine mechanical
- Cooling
- Lubrication
- Ignition
- Starting & charging
- Front suspension
- Rear suspension
- Drive shaft / propeller shaft
- Brake
- Parking brake
- Automatic transmission / trans
- Manual transmission/transaxle
- Clutch
- Steering column
- Power steering
- Heater & air conditioner
- Supplemental restraint system
- Seat belt
- Lighting
- Wiper & washer
- Audio & visual system
- Communication system
- Windshield/windowglass/mirror
- Instrument panel/meter
- Sliding roof/convertible
- Engine hood/door
- Exterior/interior trim
- Cruise control
Other materials:
Battery
Check the battery as follows.
■ Battery exterior
Make sure that the battery terminals are not corroded and that there are no
loose connections, cracks, or loose clamps.
1 Terminals
2 Hold-down clamp
■Before recharging
When recharging, the battery produces hydrogen gas which is ...
Inspection
1. Windshield wiper switch assy
Continuity check
check the continuity of each terminal of the connector.
Front wiper switch
Standard:
Front washer switch
Standard:
W/o intermittent time adjust:
intermittent operation check
connect the voltmeter (+) te ...
Evap monitor (vacuum pressure monitor) (continued)
Preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.*
Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35
°C).
Intake air temperature (iat) is between 40°f and 95 ...


