Toyota Corolla (E120): Brake
Preparation
Sst
Recomended tools
Equipment
Lubricant
Other materials:
Body rocker panel moulding lh
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove body rocker panel moulding lh
Remove the 8 retainers.
using a screwdriver, remove the moulding.
Hint:
tape the screwdriver tip before use.
remove the 7 clips from the moulding.
2. Insta ...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Safety information for
Safety Connect
Important! Read this information
before using Safety Connect.
■ Exposure to radio frequency
signals
The Safety Connect system
installed in your vehicle is a
low-power radio transmitter and
receiver. It receives and also
sends out radio frequency (RF)
signals.
In August 1996, the Federal
Communica ...