Toyota Corolla (E120): Parking brake

Preparation

Sst

Equipment

Equipment

Automatic transmission / trans

    Share this page:

    Other materials:

    Dtc check/clear
    Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

    For vehicles equipped with catalytic converter
    Caution: if large amount of unburned fuel flows into the converter, it may cause overheating and a fire hazard. To prevent this, observe the following precautions. Use only unleaded gasoline.  avoid prolonged idling. Avoid running the engine at idle speed for more than 20 minutes. ...

    On–vehicle inspection
    1. Inspect front axle hub bearing  remove the front wheel.  separate the front disc brake caliper assy .  remove the front disc.  inspect the bearing backlash. Using a dial indicator, check the backlash near the center of the axle hub. Maximum: 0.05 Mm (0. ...