Toyota Corolla (E120): Engine hood/door

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Exterior/interior trim

    Share this page:

    Other materials:

    Overhaul
    1. Remove w/head taper screw plug no.2 Using a socket hexagon wench 10, remove the taper screw plug and gasket. 2. Remove valve lifter Remove the valve lifters from the cylinder head. 3. Remove valve Place the cylinder head on wooden blocks.  using sst, compres ...

    Safe Exit Assist
    The safe exit assist is a system that uses rear side radar sensors installed on the inner side of the rear bumper to help occupants judge if an approaching vehicle or bicycle may collide with a door when opening it or cancel opening of the door, to reduce the possibility of a collision. WARNING ■C ...

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...