Toyota Corolla (E120): Sliding roof/convertible

Preparation

Recomended tools

Equipment

Equipment

Engine hood/door

    Share this page:

    Other materials:

    If a warning light turns on or a warning buzzer sounds
    Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system. However, if this continues to occur, have the vehicle inspected by your Toyota dealer. Actions to ...

    Adjustment
    1. Inspect and adjust clutch pedal sub–assy Turn over the floor carpet.  check that the pedal height is correct. Pedal height from asphalt sheet: 135.8 – 145.8 Mm (5.346 – 5.740 In.)  adjust the pedal height. Loosen the lock nut and turn the stopper bolt until ...

    Diagnostic trouble code chart
    Notice: when removing the part, turn the ignition switch to off. Hint: using sst 09843–18040, it connect the terminal tc and cg of dlc3. If any abnormality is not found when inspecting parts, inspect the ecu and ground points for poor contact. If a malfunction code is displayed during ...