Toyota Corolla (E120): Instrument panel/meter

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Seat

Seat

Preparation

Equipment

Theft deterrent & door lock

Theft deterrent & door lock

Preparation

Recomended tools

Sliding roof/convertible

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect transmission wire(s1) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

    Evap monitor (vacuum pressure monitor)
    Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

    Overhaul
    1. Precaution 2. Disconnect battery negative terminal 3. Inspect place front wheels facing straight ahead 4. Remove horn button assy Notice: if the airbag connector is disconnected with the ignition switch being at on, dtcs will be recorded.  using a torx socket wrench, loosen the ...