Toyota Corolla (E120): Windshield/windowglass/mirror

Preparation

Recomended tools

Equipment

Equipment

Ssm

Ssm

Instrument panel/meter

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Wiring diagram
    1 Inspect terminal voltage(pi) (a) turn Turn the ignition switch to on.  measure voltage between terminal 5 (pi) of cruise control ecu assy and body ground, when the cruise control main switch button is on and off. Ok: 2 Inspect combination meter assy 3 Check harn ...

    Removal and installation of engine intake parts
    If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.  when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.  when inst ...