Toyota Corolla (E120): Circuit description

The side airbag sensor assy (lh) circuit consists of the diagnosis circuit and lateral deceleration sensor, etc.

It receives signals from the lateral deceleration sensor, judges whether or not the srs must be activated, and detects diagnosis system malfunction.

Dtc b1141/33 is recorded when occurrence of a malfunction in the side airbag sensor assy (lh) is detected.

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

    Follow the correction procedures. (vehicles with a smart key system and with a drive monitor display)
    After taking the specified steps to correct the suspected problem, check that the warning light turns off. ■SRS warning light This warning light system monitors the airbag sensor assembly, front impact sensors, side impact sensors (front door), side impact sensors (front), side impac ...

    Inspection procedure
    Hint: if dtc p0441 (purge flow), p0446 (vsv for ccv or vsv for pressure switching valve), p0451, p0452 or p0453  is output with dtc p0442 or p0456 , first troubleshoot dtc p0441, p0446, p0451, p0452 or p0453. If no malfunction is detected, troubleshoot dtc p0442 or p0456 next. ...